Single-Server License HPE Smart Array SR SmartCache (Single Key/Single Server) LTU D7S26A Used to purchase a license for one server. Contains one license per server, a printed license entitlement certificate, end user license agreement, and license key installation card delivered via physical shipment. Hi All, For the above mentioned server I can find this in the specs: Hot Plug SAS/SATA Models: HP P410 Smart Array Controller RAID 0,1,10, 5 We've got the 4 hot plug backplane installed with 3 disks of 750Gb but I can still only configure either raid 0 OR raid 1+0. I would like to configure raid. HP Smart Array Advanced Pack 8 HP Smart Array Advanced Pack About SAAP SAAP is a collection of additional and advanced controller features embedded in the firmware of select Smart Array controllers. To access SAAP features, activate the software with a registered license key. SAAP 1.0 provides the following features:. RAID 6 (ADG). RAID 60. Installing the HP Smart Array Hot Plug Advanced Pack for B110i license key When installed and activated, the HP Hot Plug Advanced Pack license key enables the user to remove and install hard drives without powering down the server. For proper hot-plug operation, the following items are required:.The HP Hot Plug Advanced Pack license key. Benefits HP Smart Array HP Smart Host Bus Adapter HP Dynamic Smart Array Data protection Keeps your data available and the server running while a failed drive is being replaced, as a fault tolerant feature of HP Smart Array Controllers. Advanced Data Guarding (RAID 6) allocates two sets of parity data across drives.
Hp Smart Array Advanced Pack 2.0 Evaluation License Key
Drives are not recognized
Hp Smart Array Advanced Pack Evaluation License Key Generator
Action:
Hp Smart Array Advanced Pack License Key Trial
- Be sure no power problems exist.
- Be sure no loose connections exist.
- Check for available updates on any of the following components:
- Smart Array Controller firmware
- Dynamic Smart Array driver
- Host bus adapter firmware
- Expander backplane SEP firmware
- System ROM
- Be sure the drive or backplane is cabled properly.
- Check the drive LEDs to be sure they indicate normal function. For information on drive LEDs, see 'Hot-plug drive LED definitions.' For server-specific drive LED information, see the server documentation in the Hewlett Packard Enterprise Information Library.
- Be sure the drive is supported. To determine drive support, see the server QuickSpecs on the Hewlett Packard Enterprise website.
- Power cycle the server. If the drive appears, check to see if the drive firmware needs to be updated.
- Be sure the drive bay is not defective by installing the hard drive in another bay.
- When the drive is a replacement drive on an array controller, be sure that the drive is the same type and of the same or larger capacity than the original drive.
- Run HPE Insight Diagnostics. Then, replace failed components as indicated.
- When using an array controller, be sure the drive is configured in an array. Run HPE SSA.
- Be sure that the correct controller drivers are installed and that the controller supports the hard drives being installed.
- If the controller supports Smart Array Advanced Pack (SAAP) license keys and the configuration is dual domain, be sure the SAAP license key is installed. For more information, see the Hewlett Packard Enterprise website.
- If SAS expanders are used, be sure the Smart Array controller contains a cache module.
- If a storage enclosure is used, be sure the storage enclosure is powered on.
- If a SAS switch is used, be sure disks are zoned to the server using the Virtual SAS Manager.
IMPORTANT: The HPE Dynamic Smart Array B140i RAID controller and the AHCI do not support SAS drives.
- If the HPE Dynamic Smart Array B140i RAID controller is installed on the server, be sure that RAID mode is enabled in HPE UEFI System Utilities.